NORSTAR BADGER SPOOLGUN AND SWITCH FOR MILLERMATIC 135 & 175 MIG WELDERS

BADGER & MM 135 SWITCH

NORSTAR BADGER SPOOLGUN AND SWITCH FOR MILLERMATIC 135 & 175 MIG WELDERS

 

Product DescriptionSpoolgun & switch Kit

NORSTAR BADGER SPOOLGUN AND SWITCH FOR MILLERMATIC 135 & 175 MIG WELDERS

THIS KIT FITS THESE 2 MODELS 

(You can hook up the spoolgun  and a miller 300409 switch kit . If your
Serial# is LC175022 and above ( with the 2 pin square drive motor plugs)
the switch plugs into the harness . If it is a lower serial number , you have to do some wiring , but not hard to do)

INSTRUCTIONS ARE INCLUDED

REMOVE MM COVER 

UNPLUG THE DRIVE MOTOR FROM THE PC BOARD 

DRILL A HOLE FOR THE SWITCH INSIDE WHERE SHOWS

PLUG IN THE WHITE PLUGS ON THE SWITCH INTO THE PC BOARD AND THE DRIVE MOTOR PLUG

PLUG IN THE RED AND BLACK WIRES INTO THE EMPTY 2 PINS ON THE 4 PIN TRIGGER RECEPTACLE

IF THE SPOOLGUN RUNS BACKWARDS REVERSE THE RED AND BLACK WIRES ON THE SWITCH( NOT THE 4 PIN RECEPTACLE)

 

2 thoughts on “NORSTAR BADGER SPOOLGUN AND SWITCH FOR MILLERMATIC 135 & 175 MIG WELDERS”

Leave a Reply

Your email address will not be published. Required fields are marked *